How to deal with the air leakage of the inflatable tent

If you find that there is an air leak, you can wipe the air column clean first, and then smear the surface with soapy water to check for air leaks. If the air leak point is a very small hole, you can use a small piece of round repair cloth (inside the standard configuration of any size of inflatable tent), and then brush some glue, after the glue dries (important, you must wait for the special glue to dry After it is pasted) on the leak point, the bonding is tight. If the air leak is glued at the air column thermal seam, it can be handled in the following steps:
1. Clean the bonding surface first.
2. The inflatable tent will be equipped with a bottle of glue, special glue for the air column of the inflatable tent, brush it on the pre-adhesive surface, it must be evenly painted, and the thickness is appropriate. After brushing the picture twice, it can be glued.
3. The shape of the adhesive interface must be designed to be circular or oval, try to avoid square and acute-angled interface shapes, and the overlapping width should not be less than 30mm.
4. After the glue volatilizes, it can be bonded. The patch must be flat and free of wrinkles. Roll it and scrape it flat. At the same time, use a hair dryer to supply heat to facilitate bonding. After 6 hours of bonding, it can be inflated and used.